Chaparral Fibre Channel -to-SCSI Router Chaparral FS 1310 Manual de usuario descargar pdf (Pagina 25)

Installing the Router

2-9

To connect to the Fibre Channel port:

Be sure the router is turned off.

Insert the GBIC into the Fibre Channel port.

See Figure 2-9 on page 2-7. The GBIC is keyed and can only go in one way.

Be sure that the GBIC locks into place.

Connect one end of the Fibre Channel cable to the GBIC.

Connect the other end of the Fibre Channel cable to a server’s HBA or to an

arbitrated loop hub or fabric switch.

Connecting to the RS-232 Port

You use the RS-232 port to update the firmware, configure, and monitor the router using a

VT-100/ANSI computer with a terminal emulator. For more information about the

configuration and management capabilities, see Chapter 3, Configuring the Router.

You must use the RS-232 cable that came with the router or one configured like it. The

RS-232 cable is a standard 6-conductor flatline cable with an RJ-12 to DB-9 adapter. The

DB-9 pinout is as follows:

The RJ-12 pinout is transparent.

Configure the RS-232 port in your terminal emulator software using the following

settings:

Baud rate: 9600, 19200, 38400, 57600, or 115200; 115200 best for downloading

firmware upgrades

Data Bits: 8

Stop Bits: 1

Parity: None

Flow Control: None

To connect to the RS-232 port:

Be sure the router is turned off.

Using the RS-232 cable that came with the router, connect the RJ-12 end of the cable

into the RS-232 serial port on the router.

See Figure 2-9 on page 2-7.

Table 2-10. DB-9 pinout

Pin Function

2Transmit

3 Receive

5Ground

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 95 96

Sin comentarios

Chaparral Fibre Channel -to-SCSI Router Chaparral FS 1310 Manual de usuario Pagina 25